DEERY Super Stretch is a fast curing, premium quality, hot applied single component crack & joint sealant. Our best all around sealant. Only the most appropriate high quality synthetic elastomers, polymers, and anti-oxidants meeting exacting standards are used in combination with select asphalt plasticizers and naturally occurring reinforcing materials. The sealant contains no solvent, is highly waterproof and resistant to a wide range of salts, bases, and organic materials. Super Stretch is tested for low temperature flexibility at -0Â°F (-18Â°C). VOC=0 g/l. 1 - 30 lb. Asphalt Sealant. USE:
DEERY Super Stretch is an excellent sealant for road, airport and parking area applications for sealing longitudinal and traverse joints and random cracks in Asphalt or Concrete pavements where a fast curing sealant is desirable. The materialâ€™s superior combination of fast melting, low viscosity and above average high and low temperature properties result in a sealant preferred by many experienced applicators and end users alike. DEERY Super Stretch is recommended for use in extreme high temperature conditions. APPLICATION:
DEERY Super Stretch is pre-reacted and can be applied immediately after heating to Recommended Application Temperature. With pavement temperature at 40Â°F (4Â°C) or higher, place material into clean, dry crack or prepared reservoir by means of a hand-held pour pot, wheeled push bander or wand applicator. Squeegee any excess sealant tight to pavement surface. Excessive over-banding should be avoided. Pavement may be warmed to 40Â°F (4Â°C) or higher with a hot air lance. HEATING:
Sealant shall be heated in an approved direct fire or hot-oil jacketed melter capable of constant mechanical agitation and equipped with a calibrated thermometer to monitor sealant temperature. Material shall be heated to and maintained at the Recommended Application Temperature during use. Material can be cooled and then reheated, but only if prolonged heating is avoided. Prolonged heating at or above Recommended Application Temperature may severely damage product. If overheating dmage occurs, immediately drain machine completely and refill with new material. Maximun heating temperature is 400 degrees F. Recommended Application Temperature is 380- 400 degrees F. Curing Time 30 minutes maximum.